Wipers

All BYD related discussions
Post Reply
Stu
Posts: 3
Joined: Tue Jan 07, 2025 11:28 am

Post by Stu »

Hi… just got my Seal delivered yesterday, all good, except the wipers.
Blades don’t seem to make proper contact with screen an leave big patches unwiped.
I’ve cleaned the blades and problem is still there, also washer jets seem very low on the screen.

Has anyone else experienced these issues and if so, did you manage to sort them yourself or did it need to go to the dealers ???

TIA

Megarax
Posts: 8
Joined: Wed Jan 08, 2025 2:34 pm

Post by Megarax »

Absolutely same as me
Looking at replacing with Bosch aero twin but shouldn’t need to on a car that’s only covered 1000miles
Anyone found DAB Radio very poor in anything other than very strong signal area? Apparently BYD aware of this

Things BYD need to address
CPD NEEDS PERMANENT WAY OR TURNING OFF
ALSO LANE DEPARTURE NEED SHORT CUT TO TURN OFF

Why are NCAP so obsessed with nannying drivers I would like them to drive in Devon lanes with lane assist on
I think the sales of underwear would go through the roof !
Stu
Posts: 3
Joined: Tue Jan 07, 2025 11:28 am

Post by Stu »

Meant to reply yesterday, I’ve sorted the issue myself, turns out it left the factory with two passenger blades fitted, found the drivers side blade in a box in the boot ????

How the hell it passed factory checks and PDI I’ll never know 🤷‍♂️
Megarax
Posts: 8
Joined: Wed Jan 08, 2025 2:34 pm

Post by Megarax »

Interesting dealer in Plymouth wants my car in to try and sort
Megarax
Posts: 8
Joined: Wed Jan 08, 2025 2:34 pm

Post by Megarax »

Just checked my wipers are 2 different sizes so correct
But still leave a line of unwiped .thought the screen was scratched but very vigorous rubbing sorted it
Stu
Posts: 3
Joined: Tue Jan 07, 2025 11:28 am

Post by Stu »

There were three sizes of blade with mine, small, medium and the one I fitted, large… hope you get sorted
Summersl
Posts: 2
Joined: Fri Jan 10, 2025 10:47 am

Post by Summersl »

Just found out no warning when washer fluid is low
Megarax
Posts: 8
Joined: Wed Jan 08, 2025 2:34 pm

Post by Megarax »

took my seal in yesterday to get washers raised but if they are raised any higher they hit the back of the bonnet
so stuck with where they are
have ordered a set of bosch aero twin off amazon will report back if any better
Post Reply